Filter
Top Products
Chapter 25 IPSec VPN
ZyWALL USG 300 User’s Guide
470
• See Section 25.5 on page 495 for IPSec VPN background information.
• See Section 5.3 on page 79 for the IPSec VPN quick setup wizard.
• See Section 7.5 on page 139 for an example of configuring IPSec VPN.
• See Section 7.6 on page 142 for an example of how to configure a hub-and-
spoke IPSec VPN without using a VPN concentrator.
25.1.3 Before You Begin
This section briefly explains the relationship between VPN tunnels and other
features. It also gives some basic suggestions for troubleshooting.
You should set up the following features before you set up the VPN tunnel.
• In any VPN connection, you have to select address objects to specify the local
policy and remote policy. You should set up the address objects first.
• In a VPN gateway, you can select an Ethernet interface, virtual Ethernet
interface, VLAN interface, or virtual VLAN interface to specify what address the
ZyWALL uses as its IP address when it establishes the IKE SA. You should set up
the interface first. See Chapter 13 on page 289.
• In a VPN gateway, you can enable extended authentication. If the ZyWALL is in
server mode, you should set up the authentication method (AAA server) first.
The authentication method specifies how the ZyWALL authenticates the remote
IPSec router. See Chapter 44 on page 749.
• In a VPN gateway, the ZyWALL and remote IPSec router can use certificates to
authenticate each other. Make sure the ZyWALL and the remote IPSec router
will trust each other’s certificates. See Chapter 46 on page 765.
25.2 The VPN Connection Screen
Click Configuration > VPN > IPSec VPN to open the VPN Connection screen.
The VPN Connection screen lists the VPN connection policies and their
associated VPN gateway(s), and various settings. In addition, it also lets you
activate / deactivate and connect / disconnect each VPN connection (each IPSec