Filter
Top Products
Chapter 49 Endpoint Security
ZyWALL USG 300 User’s Guide
801
49.2 Endpoint Security Screen
The Endpoint Security screen displays the endpoint security objects you have
configured on the ZyWALL.
Click Configuration > Object > Endpoint Security to display the screen.
Figure 531 Configuration > Object > Endpoint Security
The following table gives an overview of the objects you can configure.
Table 229 Configuration > Object > Endpoint Security
LABEL DESCRIPTION
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to open a screen where
you can modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The ZyWALL confirms you
want to remove it before doing so.
Object
References
Select an entry and click Object References to open a screen that shows
which settings use the object. See Section 13.3.2 on page 303 for an
example.
Object Name This field displays the descriptive name that identifies this object.
Description If the entry has a description configured, it displays here.
Endpoint
Operating
System
This is the type of operating system that the user’s computer must be
using.
Checking
Failure
Message
Enter a message to display when a user’s computer fails the endpoint
security check. Use up to 1023 characters (0-9a-zA-Z;/?:@=+$\.-
_!*'()%,”). For example, “Endpoint Security checking failed. Please
contact your network administrator for help.”.