Filter
Top Products
Configuring Spanning Tree Parameters Configuring Spanning Tree Bridge Parameters
OmniSwitch 6600 Family Network Configuration Guide April 2006 page 5-13
Note that explicit commands using the cist and msti keywords are required to define an MSTP (802.1s)
configuration. Implicit commands are only allowed for defining STP or RSTP configurations. See
Chapter 6, “Using 802.1s Multiple Spanning Tree,” for more information about these keywords and using
implicit and explicit commands.
The following is a summary of Spanning Tree bridge configuration commands. For more information
about these commands, see the OmniSwitch CLI Reference Guide.
Commands Type Used for ...
bridge protocol Implicit Configuring the protocol for a VLAN instance when the
1x1 mode is active or the single Spanning Tree instance
when the flat mode is active.
bridge cist protocol Explicit Configuring the protocol for the single flat mode instance.
bridge 1x1 protocol Explicit Configuring the protocol for a VLAN instance.
bridge priority Implicit Configuring the priority value for a VLAN instance or the
flat mode instance.
bridge cist priority Explicit Configuring the priority value for the single flat mode
instance.
bridge msti priority Explicit Configuring the protocol for an 802.1s Multiple Spanning
Tree Instance (MSTI).
bridge 1x1 priority Explicit Configuring the priority value for a VLAN instance.
bridge hello time Implicit Configuring the hello time value for a VLAN instance
when the 1x1 mode is active or the single Spanning Tree
instance when the flat mode is active.
bridge cist hello time Explicit Configuring the hello time value for the single flat mode
instance.
bridge 1x1 hello time Explicit Configuring the hello time value for a VLAN instance.
bridge max age Implicit Configuring the maximum age time value for a VLAN
instance when the 1x1 mode is active or the single Span-
ning Tree instance when the flat mode is active.
bridge cist max age Explicit Configuring the maximum age time value for the single
flat mode instance.
bridge 1x1 max age Explicit Configuring the maximum age time value for a VLAN
instance.
bridge forward delay Implicit Configuring the forward delay time value for a VLAN
instance when the 1x1 mode is active or the single Span-
ning Tree instance when the flat mode is active.
bridge cist forward delay Explicit Configuring the forward delay time value for the single
flat mode instance.
bridge 1x1 forward delay Explicit Configuring the forward delay time value for a VLAN
instance.
bridge bpdu-switching N/A Configuring the BPDU switching status for a VLAN.