Filter
Top Products
Verifying the IP Configuration Configuring IP
page 14-24 OmniSwitch 6600 Family Network Configuration Guide April 2006
Displaying UDP Information
UDP is a secondary transport-layer protocol that uses IP for delivery. UDP is not connection-oriented and
does not provide reliable end-to-end delivery of datagrams. But some applications can safely use UDP to
send datagrams that do not require the extra overhead added by TCP. Use the show udp statistics
command to display UDP statistics. Use the show udp ports command to display UDP port information.
Verifying the IP Configuration
A summary of the show commands used for verifying the IP configuration is given here:
For more information about the displays that result from these commands, see the OmniSwitch CLI Refer-
ence Guide.
show ip interface Displays the usability status of interfaces configured for IP.
show ip route Displays the IP Forwarding table.
show ip route-pref Displays a list of all routes (static and dynamic) that exist in the IP
router database.
show ip config Displays IP configuration parameters.
show ip protocols Displays switch routing protocol information and status.
show ip service Displays the current status of TCP/UDP service ports. Includes service
name and well-known port number.
show arp Displays the ARP table.
show arp filter Displays the ARP filter configuration for the switch.
show icmp control This command allows the viewing of the ICMP control settings.
show ip dos config Displays the configuration parameters of the DoS scan for the switch.
show ip dos statistics Displays the statistics on detected port scans for the switch.