Filter
Top Products
Port Mapping Specifications Configuring Port Mapping
page 9-2 OmniSwitch 6600 Family Network Configuration Guide April 2006
Port Mapping Specifications
Port Mapping Defaults
The following table shows port mapping default values.
Quick Steps for Configuring Port Mapping
Follow the steps below for a quick tutorial on configuring port mapping sessions. Additional information
on how to configure each command is given in the subsections that follow.
1 Create a port mapping session with/without, user/network ports with the port mapping user-port
network-port command. For example:
-> port mapping 8 user-port 1/2 network-port 1/3
2 Enable the port mapping session with the port mapping command. For example:
-> port mapping 8 enable
Note. You can verify the configuration of the port mapping session by entering show port mapping
followed by the session ID
-> show port mapping 3
SessionID USR-PORT NETWORK-PORT
-----------+----------------+------------------
8 1/2 1/3
You can also verify the status of a port mapping session by using the show port mapping status
command.
Ports Supported Ethernet (10 Mbps)/Fast Ethernet (100 Mbps)/Gigabit
Ethernet (1 Gb/1000 Mbps)/10 Gigabit Ethernet (10
Gb/10000 Mbps).
Mapping Sessions Eight sessions supported per standalone switch and
stack.
Parameter Description CLI Command Default Value/Comments
Mapping Session
Creation
port mapping user-port network-port No mapping sessions
Mapping Status
configuration
port mapping Disabled
Port Mapping Direction port mapping Bidirectional