Filter
Top Products
Configuring 802.1Q Configuring an 802.1Q VLAN
OmniSwitch 6600 Family Network Configuration Guide April 2006 page 11-5
Configuring an 802.1Q VLAN
The following sections detail procedures for creating 802.1Q VLANs and assigning ports to 802.1Q
VLANs.
Enabling Tagging on a Port
To set a port to be a tagged port, you must specify a VLAN identification (VID) number and a port
number. You may also optionally assign a text identification.
For example, to configure port 4 on slot 3 to be a tagged port, enter the following command at the CLI
prompt:
-> vlan 5 802.1q 3/4
Tagging would now be enabled on port 3/4, with a VID of 5.
To add tagging to a port, and label it with a text name, you would enter the text identification following
the slot and port number. For example, to enable tagging on port 4 of slot 3 with a text name of port tag,
enter the command in the following manner:
-> vlan 5 802.1q 3/4 “port tag”
The tagged port would now also be labeled port tag. Note that you must use quotes around the text
description.
The VLAN used to handle traffic on the tagged port must be created prior to using the vlan 802.1q
command. Creating a VLAN is described in Chapter 4, “Configuring VLANs.”
For more specific information, see the vlan 802.1q command section in the OmniSwitch CLI Reference
Guide.