Filter
Top Products
Modifying Policy Servers Managing Policy Servers
page 23-4 OmniSwitch 6600 Family Network Configuration Guide April 2006
Modifying Policy Servers
Policy servers are automatically configured when the server is installed; however, policy server parame-
ters may be modified if necessary.
Note. SSL configuration must be done manually through the policy server command.
Modifying LDAP Policy Server Parameters
Use the policy server command to modify parameters for an LDAP policy server.
Keywords for the command are listed here:
For information about policy server parameter defaults, see “Policy Server Defaults” on page 23-2.
Disabling the Policy Server From Downloading Policies
Policy servers may be prevented from downloading policies to the switch. By default, policy servers are
enabled to download policies.
To disable a server, use the policy server command with the admin keyword and down option.
-> policy server 10.10.2.3 admin down
In this example, an LDAP server with an IP address of 10.10.2.3 will not be used to download policies.
Any policies already downloaded to the switch are not affected by disabling the server.
To re-enable the server, specify up.
-> policy server 10.10.2.3 admin up
The server is now available for downloading policies.
To delete a policy server from the configuration, use the no form of the command with the relevant IP
address:
-> no policy server 10.10.2.3
If the policy server is not created on the default port, the no form of the command must include the port
number. For example:
-> no policy server 10.10.2.4 5000
Policy server keywords
port
admin
preference
user
password
searchbase
ssl