Filter
Top Products
Configuring Dynamic Link Aggregation Modifying Dynamic Link Aggregate Group Parameters
OmniSwitch 6600 Family Network Configuration Guide April 2006 page 13-21
Deleting a Dynamic Aggregate Actor Administrative Key
To remove an actor switch administrative key from a dynamic aggregate group’s configuration use the no
form of the lacp linkagg actor admin key command by entering lacp linkagg followed by the dynamic
aggregate group number, and no actor admin key.
For example, to remove an administrative key from dynamic aggregate group 4 you would enter:
-> lacp linkagg 4 no actor admin key
Modifying the Dynamic Aggregate Group Actor System Priority
By default, the dynamic aggregate group actor system priority is 0. The following subsections describe
how to configure a user-specified value and how to restore the value to its default value with the
lacp linkagg actor system priority command.
Configuring a Dynamic Aggregate Group Actor System Priority
You can configure a user-specified dynamic aggregate group actor system priority value to a value rang-
ing from 0 to 65535 by entering lacp linkagg followed by the dynamic aggregate group number, actor
system priority, and the new priority value.
For example, to change the actor system priority of dynamic aggregate group 4 to 2000 you would enter:
-> lacp linkagg 4 actor system priority 2000
Restoring the Dynamic Aggregate Group Actor System Priority
To restore the dynamic aggregate group actor system priority to its default (i.e., 0) value use the no form
of the lacp linkagg actor system priority command by entering lacp linkagg followed by the dynamic
aggregate group number and no actor system priority.
For example, to restore the actor system priority to its default value on dynamic aggregate group 4 you
would enter:
-> lacp linkagg 4 no actor system priority
Modifying the Dynamic Aggregate Group Actor System ID
By default, the dynamic aggregate group actor system ID (MAC address) is 00:00:00:00:00:00. The
following subsections describe how to configure a user-specified value and how to restore the value to its
default value with the lacp linkagg actor system id command.
Configuring a Dynamic Aggregate Group Actor System ID
You can configure a user-specified dynamic aggregate group actor system ID by entering lacp linkagg
followed by the dynamic aggregate group number, actor system id, and the user-specified MAC address
(in the hexadecimal format of xx:xx:xx:xx:xx:xx), which is used as the system ID.
For example, to configure the system ID on dynamic aggregate group 4 as 00:20:da:81:d5:b0 you would
enter:
-> lacp linkagg 4 actor system id 00:20:da:81:d5:b0