Filter
Top Products
Configuring Dynamic Link Aggregate Groups Configuring Dynamic Link Aggregation
page 13-18 OmniSwitch 6600 Family Network Configuration Guide April 2006
As an option, you can use the ethernet, fastethernet, and gigaethernet keywords before the slot and port
number to document the interface type or make the command look consistent with early-generation Alca-
tel CLI syntax. For example, to configure actor administrative key of 10 and to document that the port is a
10 Mbps Ethernet port to slot 4 port 1, enter:
-> lacp agg ethernet 4/1 actor admin key 10
Note. The ethernet, fastethernet, and gigaethernet keywords do not modify a port’s configuration. See
Chapter 1, “Configuring Ethernet Ports,” for information on configuring Ethernet ports.
Removing Ports from a Dynamic Aggregate Group
To remove a port from a dynamic aggregate group, use the no form of the lacp agg actor admin key
command by entering lacp agg no followed by the slot number, a slash (/), and the port number.
For example, to remove port 4 in slot 4 from any dynamic aggregate group you would enter:
-> lacp agg no 4/4
Ports must be deleted in the reverse order in which they were configured. For example, if port 9 through
16 were configured to join dynamic aggregate group 2 you must first delete port 16, then port 15, and so
forth. The following is an example of how to delete ports in the proper sequence from the console
-> lacp agg no 4/24
-> lacp agg no 4/23
-> lacp agg no 4/22