Filter
Top Products
RIP Specifications Configuring RIP
page 16-2 OmniSwitch 6600 Family Network Configuration Guide April 2006
RIP Specifications
RIP Defaults
The following table lists the defaults for RIP configuration through the ip rip command.
RFCs Supported RFC 1058–RIP v1
RFC 2453–RIP v2
RFC 1722–RIP v2 Protocol Applicability Statement
RFC 1724–RIP v2 MIB Extension
Maximum Number of RIP Routes 2048
Description Command Default
RIP Status ip rip status disable
RIP Forced Hold-down Interval ip rip force-holddowntimer 0
RIP Interface Metric ip rip interface metric 1
RIP Interface Send Version ip rip interface send-version v2
RIP Interface Receive Version ip rip interface recv-version both
RIP Host Route ip rip host-route enable
RIP Route Tag ip rip route-tag 0
Redistribution Status ip rip redist status disable
Redistribution Metric ip rip redist metric 0
Redistribution Filter Effect ip rip redist-filter effect permit
Redistribution Filter Metric ip rip redist-filter metric 0
Redistribution Filter Control ip rip redist-filter redist-control all-subnets
Redistribution Filter Route Tag ip rip redist-filter route-tag 0
RIP Interface Authentication ip rip interface auth-type none