Filter
Top Products
Verifying the Port Mapping Configuration Configuring Port Mapping
page 9-6 OmniSwitch 6600 Family Network Configuration Guide April 2006
Example Port Mapping Configuration Steps
The following steps provide a quick tutorial that configures the port mapping session shown in the
diagram on page 9-5.
1 Create two port mapping sessions on Switch A using the following commands:
-> port mapping 1 user-port 2/1-2 network-port 1/1-2
-> port mapping 2 user-port 3/1-3 network-port 1/3
2 Configure session 1 on Switch A in the unidirectional mode using the following command:
-> port mapping 1 unidirectional
3 Enable both the sessions on Switch A using the following commands:
-> port mapping 1 enable
-> port mapping 2 enable
Similarly, create and enable a port mapping session 1 on Switch D by entering the following commands:
-> port mapping 1 user-port 2/1-2 network-port 1/1
-> port mapping 1 enable
Verifying the Port Mapping Configuration
To display information about the port mapping configuration on the switch, use the show commands listed
below:
For more information about the displays that result from these commands, see the OmniSwitch CLI Refer-
ence Guide.
show port mapping status Displays the status of one or more port mapping sessions.
show port mapping Displays the configuration of one or more port mapping sessions.