Filter
Top Products
Diagnosing Switch Problems Remote Monitoring (RMON) Overview
OmniSwitch 6600 Family Network Configuration Guide April 2006 page 27-9
RMON Probe Defaults
The following table shows Remote Network Monitoring default values.
Global RMON Probe Defaults
Quick Steps for Enabling/Disabling RMON Probes
1 Enable an inactive (or disable an active) RMON probe, where necessary. You can also enable or
disable all probes of a particular flavor, if desired. For example:
-> rmon probes stats 4005 enable
-> rmon probes history disable
2 To verify the RMON probe configuration, enter the show rmon probes command with the keyword
for the type of probe. For example, to display the statistics probes, enter the following:
-> show rmon probes stats
The display is similar to the one shown below:
Entry Slot/Port Flavor Status Duration System Resources
-----+-----------+-----------+----------+---------------+---------------------
4001 4/1 Ethernet Active 00:25:00 275 bytes
4008 4/8 Ethernet Active 00:25:00 275 bytes
4005 4/5 Ethernet Active 00:03:03 275 bytes
3 To view statistics for a particular RMON probe, enter the show rmon probes command, with the
keyword for the type of probe, followed by the entry number for the desired RMON probe. For example:
-> show rmon probes 4005
The display will appear similar to the one shown below:
Probe’s Owner: Hawk Switch Auto Probe on Slot 4, Port 5
Entry 4005
Flavor = Ethernet, Status = Active
Time = 0 hrs 03 mins,
System Resources (bytes) = 275
For more information about these commands, see “Displaying a List of RMON Probes” on page 27-28,
“Displaying Statistics for a Particular RMON Probe” on page 27-29 or the “RMON Commands” chapter
in the OmniSwitch CLI Reference Guide.
Parameter Description CLI Command Default Value/Comments
RMON Probe Configuration rmon probes No RMON probes configured.