Filter
Top Products
Configuring Dynamic Link Aggregation Modifying Dynamic Link Aggregate Group Parameters
OmniSwitch 6600 Family Network Configuration Guide April 2006 page 13-27
Modifying the Actor Port Priority
By default, the actor port priority (used to converge dynamic key changes) is 0. The following subsec-
tions describe how to configure a user-specified value and how to restore the value to its default value
with the lacp agg actor port priority command.
Configuring the Actor Port Priority
You can configure the actor port priority to a value ranging from 0 to 255 by entering lacp agg, the slot
number, a slash (/), the port number, actor port priority, and the user-specified actor port priority.
For example, to modify the actor port priority of dynamic aggregate actor port 1 in slot 2 to 100 you
would enter:
-> lacp agg 2/1 actor port priority 100
As an option, you can use the ethernet, fastethernet, and gigaethernet keywords before the slot and port
number to document the interface type or make the command look consistent with early-generation Alca-
tel CLI syntax. For example, to modify the actor port priority of dynamic aggregate actor port 1 in slot 2 to
100 and document that the port is a fast Ethernet port you would enter:
-> lacp agg fastethernet 2/1 actor port priority 100
Restoring the Actor Port Priority
To remove a user configured actor port priority from a dynamic aggregate group actor port’s configura-
tion use the no form of the lacp agg actor port priority command by entering lacp agg, the slot number,
a slash (/), the port number, and no actor port priority.
For example, to remove a user-configured actor priority from dynamic aggregate actor port 1 in slot 2 you
would enter:
-> lacp agg 2/1 no actor port priority