Filter
Top Products
Configuring RDP Verifying the RDP Configuration
OmniSwitch 6600 Family Network Configuration Guide April 2006 page 17-11
Setting the Preference Levels for Router IP Addresses
A preference level is assigned to each router IP address contained within an advertisement packet. Hosts
will select the IP address with this highest preference level to use as the default router gateway address.
By default, this value is set to zero.
To specify a preference level for IP addresses advertised from a specific RDP interface, use the
ip router-discovery interface preference-level command. For example, the following command sets this
value to 10 for the IP address associated with the Marketing IP router interface:
-> ip router-discovery interface Marketing preference-level 10
Note that router IP address preference levels are only compared with the preference levels of other routers
that exist on the same subnet. Set preference levels low to discourage selection of a specific router.
Verifying the RDP Configuration
To display information about the RDP configuration on the switch, use the show commands listed below:
For more information about the resulting displays from these commands, see the OmniSwitch CLI Refer-
ence Guide. An example of the output for the show ip router-discovery and show ip router-discovery
interface commands is also given in “Quick Steps for Configuring RDP” on page 17-3.
show ip router-discovery Displays the current operational status of RDP on the switch. Also
includes the number of advertisement packets transmitted and the num-
ber of solicitation packets received by all RDP interfaces on the switch.
show ip router-
discovery interface
Displays the current RDP status, related parameter values, and RDP
traffic statistics for one or more switch router RDP interfaces.