Filter
Top Products
Configuring Static Link Aggregation Quick Steps for Configuring Static Link Aggregation
OmniSwitch 6600 Family Network Configuration Guide April 2006 page 12-3
Quick Steps for Configuring Static Link
Aggregation
Follow the steps below for a quick tutorial on configuring a static aggregate link between two switches.
Additional information on how to configure each command is given in the subsections that follow.
1 Create the static aggregate link on the local switch with the static linkagg size command. For example:
-> static linkagg 1 size 4
2 Assign all the necessary ports sequentially (beginning with port number 1, 9, 17, or 25 on the
OmniSwitch 6624, 6600-U24, or 6602-24; beginning with port number 1, 9, 17, 25, 33, 41, 49, or 51 on
the OmniSwitch 6648; or beginning with port number 1, 9, 17, 25, 33, 41, or 49 on the OmniSwitch 6602-
48) to the static link aggregation group on the local switch with the static agg agg num command. For
example:
-> static agg 1/1 agg num 1
-> static agg 1/2 agg num 1
-> static agg 1/3 agg num 1
-> static agg 1/4 agg num 1
3 Create a VLAN for this static link aggregate group with the vlan command. For example:
-> vlan 10 port default 1
4 Create the equivalent static aggregate link on the remote switch with the static linkagg size command.
For example:
-> static linkagg 1 size 4
5 Assign all the necessary ports sequentially (beginning with port number 1, 9, 17, or 25 on the
OmniSwitch 6624, 6600-U24, 6602-24; beginning with port number 1, 9, 17, 25, 33, 41, 49, or 51 on the
OmniSwitch 6648; or beginning with port number 1, 9, 17, 25, 33, 41, or 49 on the OmniSwitch 6602-48)
to the static link aggregation group on the remote switch with the static agg agg num command. For
example:
-> static agg 1/9 agg num 1
-> static agg 1/10 agg num 1
-> static agg 1/11 agg num 1
-> static agg 1/12 agg num 1
6 Create a VLAN for this static link aggregate group with the vlan command. For example:
-> vlan 10 port default 1