Filter
Top Products
Chapter 5 CLI – Layer 2
84 P332G-ML User’s Guide
• set port spantree Enables or disables the spanning tree for
switch ports
Page 102
• set port spantree
priority
Set the port spantree priority level Page 103
• set port spantree cost Set the port spantree cost Page 103
• set port security Enables MAC security on a range of
ports
Page 104
• set cascading Sets module cascading fault-monitoring
mode
Page 104
• set inband vlan Set the management VLAN ID Page 104
• set vlan Creates VLANs Page 105
• set port flowcontrol Set the flow control mode of a port Page 105
• set port auto-negotiation-flowcontrol-advertisement
• Set the flowcontrol advertising capabilities of a Gigabit port
Page 106
• set trunk Set the tagging mode of a port Page 106
• set spantree Enable/Disable Spanning Tree Protocol
(STP)
Page 107
• set spantree priority Set the STP Bridge priority level Page 107
• set autopartition To enable or disable autopartitioning for
modules in a stack
Page 107
• set license Enter a license number for the stack Page 109
• set ppp authentication Defines the PPP authentication method Page 109
• set ppp incoming
timeout
Sets the time after which the system
automatically disconnects an idle PPP
incoming session
Page 110
• set ppp baud-rate Sets the baud rate used in PPP sessions Page 110
•set web
aux-files-url
Set the location (url/directory) of the
P330 Device Manager Help files
Page 110
• set intelligent-multicast Enables or disables the IP multicast
filtering application
Page 111
• set intelligent-multicast
client-port-pruning
time
Sets the aging time for client ports Page 111