Filter
Top Products
Chapter 5 CLI – Layer 2
P332G-ML User’s Guide 105
Management VLAN number set to 1
Set vlan Command
Use the set vlan command to create vlans.
The syntax for this command is:
set vlan <vlan-id> [name <vlan-name>]
Example:
P330-N# set vlan 3 name v3
VLAN ID 3 is named v3.
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".
Set port flowcontrol Command
Use the set port flowcontrol command to set the send/receive mode for
flow-control frames (IEEE 802.3x or proprietary) for a full duplex port. Each
direction (send or receive) can be configured separately only for Gigabit Ethernet
ports. Proprietary flow control cannot be configured on Gigabit ports. The set
flowcontrol command cannot be used on Gigabit ports for which
autonegotiation is enabled.
The syntax for this command is:
set flowcontrol [direction] [module/port] [value]
Example:
P330-1(super)# set port flowcontrol all 2/20 on
Port 2/20 flow control administration status set to on
vlan-id vlan number
vlan-name vlan name
direction • receive/send/all
module/port • module/port number
value • on/off/proprietary