Filter
Top Products
Chapter 5 CLI – Layer 2
124 P332G-ML User’s Guide
Set radius authentication retry-number Command
Use the set radius authentication retry-number command to set the
number of times an access request is sent when there is no response.
The syntax for this command is:
set radius authentication retry number <number>
number retry number
Set radius authentication udp-port Command
Use the set radius authentication udp-port command to set the RFC
2138 approved UDP port number. Normally, the UDP port number should be set to
its default value of 1812. Some early implementations of the RADIUS server used
port number 1645.
The syntax for this command is:
set radius authentication server udp-port <number>