Filter
Top Products
Chapter 5 CLI – Layer 2
94 P332G-ML User’s Guide
Set port enable Command
Use the set port enable command to enable a port or a range of ports.
The syntax for this command is:
set port enable [mod_num/port_num]
Example:
To enable port 3 on module 2:
P330-N# set port enable 2/3
Port 2/3 enabled.
Set port disable Command
Use the set port disable command to disable a port.
The syntax for this command is:
set port disable <mod_num>/<port_num>
Example:
P330-N# set port disable 5/10
Port 5/10 disabled.
Set port speed Command
Use the set port speed command to configure the speed of a 10/100Base-T
port. If autonegotiation mode is enabled for such ports, the port's speed is
determined by autonegotiation, and an error message is thus generated if you
attempt to perform the set port speed command in this case.
The syntax for this command is:
set port speed <mod_num>/<port_num> {value}
Example:
To configure port 2 on module 2 port speed to 10 Mbps:
P330-N# set port speed 2/2 10MB
Port 2/2 speed set to 10 Mbps.
mod _num The module number
port_num The port number