Filter
Top Products
Chapter 6 CLI – Layer 3
P332G-ML User’s Guide 149
ip routing Command
Use the ip routing command to enable IP routing. The no form of this
command disables the IP routing process in the device. By default, IP routing is
enabled.
The syntax for this command is:
[no] ip routing
ip max-route-entries Command
This command exists for compatibility with P550. There is no limitation on the size
of the routing table, except for the amount of available memory.
The syntax for this command is:
[no] ip max-route-entries <value>
arp Command
Use the arp command to add a permanent entry to the Address Resolution
Protocol (ARP) cache. The no form of this command removes an entry, either a
static entry or a dynamically learned entry.
The syntax for this command is:
[no] arp <ip-address> <mac-address>
Example:
To add a permanent entry for station 192.168.7.8 to the ARP cache:
Router(configure)# arp 192.168.7.8 00:40:0d:8c:2a:01
To remove an entry to the ARP cache for the station 192.168.13.76:
Router(configure)# no arp 192.168.13.76
value number of entries
ip-address IP address, in dotted decimal format, of the station
mac-address MAC address of the local data link