Filter
Top Products
Chapter 6 CLI – Layer 3
134 P332G-ML User’s Guide
set device-mode Command
Use the device-mode command to change the Basic Mode of Operation of the
P332-ML Module between Router and Layer 2 modes.
The syntax for this command is:
set device-mode <mode>
set system contact Command
The syntax for this command is:
set system contact [contact string]
Example:
set system contact "Gabby ext.545"
set system name Command
The syntax for this command is:
set system name [name string]
Example:
Router-N> set system name "Banking System"
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".
set system location Command
The syntax for this command is:
set system location [location string]
Example:
Router-N> set system location "Floor 5,Room 12"
mode Router | Layer2