Filter
Top Products
Chapter 5 CLI – Layer 2
104 P332G-ML User’s Guide
Set port security Command
Use the set port security command to enable MAC security on a port, a range
of ports, a module, or a stack.
The syntax for this command is:
set port security { enable | disable } [<module>[/<port>]]
{ enable | disable } - set the port security enable or disable
[<module>[/<port>]] - set specific module/port
Example:
P330-N> set port security enable 1/2
Port 1/2 secured.
Note: This command is not supported in P332G-ML and P332GT-ML modules. This
command is used to set post security for ports in other P330 modules in the stack.
Set cascading Command
Use the set cascading command to enable or disable fault-trap sending for
unconnected cascading links. The default setting is disable.
The syntax for this command is:
set cascading{up|down}fault-monitoring {enable|disable}<mod-num>
Example:
P330-N# set cascading down fault-monitoring enable 1
Module 1 cascading-down fault monitoring enabled.
Set inband vlan Command
Use the set inband vlan command to set a value for the management vlan
(from 1 to 3071).
The syntax for this command is:
set inband vlan <value>
Example:
P330-N# set inband vlan 1
value A VLAN number between 1 and 3071.