Filter
Top Products
P332G-ML User’s Guide 43
Chapter 5
CLI – Layer 2
This chapter provides instructions for the configuration of your P332G-ML using
the text-based Command Line Interface (CLI or Terminal Emulation). You can also
configure your P332G-ML using the P330 Manager with its graphical user interface
(see Appendix A).
The configuration procedure involves establishing a Telnet session or a serial
connection and then using the P332G-ML’s internal CLI. See Chapter 5 for
instructions on how to establish a Telnet session or serial connection, and for a
description of CLI conventions.
The CLI is command-line driven and does not have any menus. To activate a
configuration option, you must type the desired command at the prompt and press
Enter.
User Level Commands
This section describes all commands that are available from the User level.
Following is a table of the User Level commands and command groups (all
commands are also available at the higher levels).
• session Opens a session to another P330 module or
X330 ATM Access module
Page 44
• terminal width Display or set the width of the terminal
display
Page 44
• terminal length Display or set the length of the terminal
display
Page 44
• clear screen Clears the current terminal display Page 45
• show
1
1 This command corresponds to a group of commands and is shown in a
separate
Table on Page 46
Shows the current switch parameters Page 46
• ping Sends ICMP echo request packets to another
node on the network
Page 45
• dir Show files in the System Page 74