Filter
Top Products
Chapter 5 CLI – Layer 2
44 P332G-ML User’s Guide
Session Command
Use the session command to open a session with a specific entity in a module of
the stack. For example, you can open a session with the Routing entity of a P332-ML
module in the stack, or with an the X330 ATM module entity plugged into a specific
module.
The syntax for this command is:
session [<mod_num> [switch|router|atm]]
Note: Layer 2 commands are only available if you open a switch session with the
Master module.
Router commands are described in the Layer 3 CLI Chapter in this Guide.
Example:
P330-N# session 2 router
Note: When you use the session command the security level stays the same.
Terminal Commands
Use the terminal width and terminal length commands to set the width
and length of the terminal display in characters.
The syntax for this command is:
terminal {width|length} [<characters>]
mod_num (optional) The module number.
If you do not specify this parameter, you will get the default
entity of the stack (Layer 2 session to the Master)
switch|router|atm (optional) The entity to which you want to open a session
If you do not specify this parameter, you will get the default
entity of the specific module:
switch - Layer 2 entity of the module (see Note below)
router - P332-ML Routing entity
atm - X330 Access module ATM entity