Filter
Top Products
Chapter 5 CLI – Layer 2
P332G-ML User’s Guide 85
Set logout Command
The set logout command is used to set the number of minutes until the system
automatically disconnects an idle session.
The syntax for this command is:
set logout <timeout>
Example:
To set the number of minutes until the system disconnects an idle session
automatically:
P330-N# set logout 20
Sessions will be automatically logged out after 20 minutes of
idle time.
To disable the automatic disconnection of idle sessions:
P330-N# set logout 0
Sessions will not be automatically logged out.
Set timezone Command
Use the set timezone command to assign a timezone name and set the time
difference of your P330 relative to the Coordinated Universal Time (UTC/GMT).
• set intelligent-multicast
router-port-pruning
time
Sets the aging time for router ports Page 111
• set intelligent-multicast
group-filtering-delay
time
Sets the time delay before a filter is
applied to a specific group
Page 112
• set security mode Enables or disables the stack’s MAC
security
Page 112
• set arp-aging-interval Sets the arp aging interval Page 112
• set arp-tx-interval Sets the keep-alive interval Page 113
• set welcome message Sets a welcome message to appear after
a reboot.
Page 113
timeout Number of minutes (0 to 999) until the system automatically
disconnects an idle session. Setting the value to 0 disables the
automatic disconnection of idle sessions (default is 15 minutes).