Filter
Top Products
Chapter 5 CLI – Layer 2
P332G-ML User’s Guide 115
Resetting module 4...
Nvram initialize Command
Use the nvram initialize command to reset the P330 parameters to the factory
defaults. If no options are specified for this command, only the Layer 2 parameters
will be reset.
The syntax for this command is:
nvram initialize [switch|all]
Example:
P330-N# nvram initialize
This command will force a factory default and switch-over to
the master module and disconnect your telnet session.
Do you want to continue (y/n) [n]? y
Connection closed by foreign host.
host%
Configure Command
The configure command is not used in the Layer 2 CLI. It is used with the Layer
3 CLI. Use the configure command to enter Configure Mode (See Security Levels on
page 220).
Rmon history Command
Use the rmon history command to create an RMON history entry.
The syntax for this command is:
rmon history <history index> [<module>[</port>]] interval
<interval> buckets <number of buckets> owner <owner name>
switch Resets all the switching level parameters (Layer 2 only) throughout
the stack
all Resets all parameters including licenses and routing parameters of
the Layer 3 modules present in the stack
history_index This is the history index number of this entry (it is advisable to
use the same interface number as your history index number)
module/port The module number/the port numbe.r