Filter
Top Products
Chapter 5 CLI – Layer 2
P332G-ML User’s Guide 113
Example:
P330-N# set arp-aging-interval 20
ARP aging interval was set to 20 minutes.
Set arp-tx-interval Command
Use the set arp-tx-interval command to set the keep-alive frames sending interval.
Setting the interval to 0 disables the transmission of the keep-alive frames.
The syntax for this command is:
set arp-tx-interval <value>
<value> - interval (seconds)
Example:
P330-N# set arp-tx-interval 15
ARP tx interval was set to 15 seconds.
set welcome message
Use the set welcome message command to set a welcome message to appear
after a reboot or after opening a new session (see session command) in the stack.
The syntax for this command is:
set welcome message [string]
Output Example:
P330-N# set welcome message avaya
The new welcome string is “avaya”
Note: If you wish to define a string which includes spaces, you must enclose the
entire string in quotation marks, e.g. "new york".
Sync time Command
This command synchronizes the time used by all modules in a stack.
string string - The string to be used as the welcome message.
blank - Restores the default string.