Filter
Top Products
Chapter 5 CLI – Layer 2
P332G-ML User’s Guide 95
Note: This command is not supported for P332G-ML and P332GT-ML ports. An
error message is generated if you attempt to perform the set port speed
command for P332G-ML and P332GT-ML ports.
Set port duplex Command
Use the set port duplex command to configure the duplex mode of a
10/100Base-T port. You can configure the duplex mode to either Half or Full
duplex. If autonegotiation mode is enabled for such ports, the port’s duplex mode is
determined by autonegotiation, and an error message is thus generated if you
attempt to perform the set port duplex command in this case.
Note: P332G-ML and P332GT-ML module ports work in Full duplex mode only.
The syntax for this command is:
set port duplex <mod_num>/<port_num> {full|half}
Example:
To set port 1 on module 2 to full duplex:
P330-N# set port duplex 2/1 full
Port 2/1 set to full-duplex.
Set port name Command
Use the set port name to configure a name for a port. If you do not specify a
name, the port name remains empty.
The syntax for this command is:
set port name <mod_num>/<port_num> [<name>]
Example:
P330-N# set port name 1/2 arthur
Port 1/2 name set.
name Name assigned to the port.