Filter
Top Products
Chapter 5 CLI – Layer 2
P332G-ML User’s Guide 103
The syntax for this command is:
set port spantree {enable|disable} [module/port]
Example:
Enable the spanning tree mode for port 2 on module 3.
P330-N# set port spantree enable 3/2
Set port spantree priority Command
Use the set port spantree priority command to set the priority level of a
port. This value defines the priority of a port to be blocked in case two ports with
the same costs cause a loop.
The syntax for this command is:
set port spantree priority [module/port] [value]
Set port spantree cost Command
Use the set port spantree cost command to set the cost of a port. This value
defines which port will be allowed to forward traffic if two ports with different costs
cause a loop.
The syntax for this command is:
set port spantree cost [module/port] [value]
enable|disable Enables or disables the spanning tree mode for the
specified ports.
module/port The module/port number.
module/port The module number/the port number.
value Number representing the priority of the port. The priority
level is from 0 to 255, with 0 indicating high priority and
255 indicating low priority.
module/port The module number/the port number.
value Number representing the cost.