Filter
Top Products
Chapter 5 CLI – Layer 2
P332G-ML User’s Guide 51
Show snmp retries Command
Use the show snmp retries command to display the number of retries initiated
by the Device Manager application when it tries to send SNMP messages to the
device.
The syntax for this command is:
show snmp retries
Example:
P330-N> show snmp retries
the SNMP Retries Number is 3
Show snmp timeout Command
Use the show snmp timeout command to display the default SNMP timeout in
seconds. This command is useful for access using the Device Manager.
The syntax for this command is:
show snmp timeout
Example:
P330-N> show snmp timeout
the SNMP Timeout is 2000
Show timeout Command
Use the show timeout command to display the amount of time the CLI can
remain idle before timing out in minutes. If the result is 0, there is no timeout limit.
The default is 15 minutes.
The syntax for this command is:
show timeout
Example:
P330-N> show timeout
CLI timeout is 10 minutes
Show interface Command
Use the show interface command to display information on network
interfaces.