Filter
Top Products
Chapter 5 CLI – Layer 2
P332G-ML User’s Guide 89
To enable all traps to a specific manager:
P330-N# set snmp trap 192.168.173.42 enable all
All SNMP traps enabled.
To disable SNMP config traps to a specific manager:
P330-N# set snmp trap 192.168.173.42 disable config
SNMP config traps disabled.
To add an entry in the SNMP trap receiver table with default:
P330-N# set snmp trap 192.168.173.42
SNMP trap receiver added.
Set snmp trap auth Command
Use the set snmp trap auth commands to enable/disable the sending of
SNMP traps upon SNMP authentication failure.
The syntax for this command is:
set snmp trap {enable|disable} auth
Example:
P330-N# set snmp trap enable auth
Authentication trap enabled
Set snmp retries Command
Use the set snmp retries command to set the number of retries initiated by
the Device Manager application when it tries to send SNMP messages to the device.
The syntax for this command is:
set snmp retries <number>
Set snmp timeout Command
Use the set snmp timeout command to set the SNMP timeout in seconds. This
command is useful for access using the Device Manager.
The syntax for this command is:
set snmp timeout <number>