Filter
Top Products
Chapter 5 CLI – Layer 2
P332G-ML User’s Guide 93
Set port level Command
Use the set port level command to set the priority level of a port. Untagged
(without an 802.1p priority header) packets travelling through ports set with
priority 0-3 will be served only after packets traveling through ports set with
priority 4-7 in case of congestion. Packets arriving with an 802.1p priority header
will not be modified by this command.
The syntax for this command is:
set port level <mod_num>/<port_num> {value}
Example:
To set the priority level for port 2 on module 1 to 7:
P330-N# set port level 1/2 7
Port 1/2 port level set to 7
Set port negotiation Command
Use the set port negotiation command to enable or disable autonegotiation
on a port. If autonegotiation is disabled, you can set port parameters using the
relevant CLI commands. If autonegotiation is enabled, these commands have no
effect. For Fiber Gigbit Ethernet ports it can determine the flow control (pause)
mode only.
The syntax for this command is:
set port negotiation <mod_num>/<port_num> {enable|disable}
Example:
To disable autonegotiation on port 1, module 4:
P330-N# set port negotiation 4/1 disable
Link negotiation protocol disabled on port 4/1.
value Priority level (0-7)