Filter
Top Products
Chapter 5 CLI – Layer 2
86 P332G-ML User’s Guide
The minutes parameter can only be set to 30.
The syntax for this command is:
set timezone <zone_name> <hours | hours:min>[:30]
Example:
set timezone GMT -3:30
Timezone set to 'GMT', offset from UTC is -3:30 hours
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".
Set time protocol Command
Use the set time protocol command to set the protocol for use in the system as either
SNTP protocol or TIME protocol.
The syntax for this command is:
set time protocol [sntp-protocol|time-protocol]
Example:
P330-N# set time protocol sntp-protocol
The protocol has been set to SNTP protocol
P330-N# set time protocol time-protocol
The protocol has been set to TIME protocol
Set time server Command
The set time server command is used to set the TIME server address.
The syntax for this command is:
set time server <ip>
Set time client Command
The set time client command is used to enable or disable the periodic
network time acquisition by the switch from the network time server (SNTP or
ip IP address of the TIME server.