Filter
Top Products
Chapter 6 CLI – Layer 3
P332G-ML User’s Guide 157
RIP Commands
Configure Mode
router rip Command
Use the router rip command to configure the Routing Information Protocol
(RIP). The no form of this command disables RIP. The default state is disabled.
The syntax for this command is:
[no] router rip
Example:
To enable the RIP protocol:
Router-N(configure)# router rip
Table 6.3 RIP Commands
Command Page
router rip 157
network 158
redistribute 158
ip rip rip-version 159
ip rip default-metric 159
ip rip send-receive-mode 160
ip rip default-route-mode 160
ip rip poison-reverse 161
ip rip split-horizon 161
ip rip authentication mode 161
ip rip authentication key 162