Filter
Top Products
Chapter 5 CLI – Layer 2
118 P332G-ML User’s Guide
Note: Create the file into which you wish to upload the stack-level parameters prior
to executing this command.
The syntax for this command is:
copy stack-config tftp <filename> <ip>
Example:
P330-N# copy stack-config tftp c:\conf.cfg 192.168.49.10
Beginning upload operation ...
This operation may take a few minutes...
Please refrain from any other operation during this time.
For more information , use 'upload status' command
********************************************************************
* If you are currently running the P330 Device Manager application,*
* it is recommended to exit from it before performing configuration*
* download operations. *
********************************************************************
Copy module-config tftp Command
Use the copy module-config tftp command to upload the module-level
parameters from the current NVRAM running configuration into a file via TFTP.
If an error occurred during upload (you can check this using the command show
tftp upload status) you must fix the problem. The following is a list of
possible problems:
a You did not create an empty text file at the destination server (0 Bytes).
b You do not have the correct path to the file.
c The destination server is not active/on.
d The destination server is unreachable.
Then, perform the upload procedure again twice as follows:
a Delete the destination file and recreate a correctly named empty file at the
destination server (0 Bytes)
b Type the command copy module-config tftp for the first time.
c Delete the destination file and recreate a correctly named empty file at the
destination server (0 Bytes)
d Type the command copy module-config tftp again, a second time.
filename file name (full path)
ip The ip address of the TFTP server