Filter
Top Products
CLI - Layer 2 Command Index
208 P332G-ML User’s Guide
clear port mirror 81
set logout 85
set timezone 85
set time protocol 86
set time server 86
set time client 86
set ip route 87
set snmp community 88
set snmp trap 88
set snmp trap auth 89
set snmp retries 89
set snmp timeout 89
set system location 90
set system name 90
set system contact 90
set device-mode 91
set interface 91
set interface ppp 91
set port level 93
set port negotiation 93
set port enable 94
set port disable 94
set port speed 94
set port duplex 95
set port name 95
set port trap 96
set port vlan 96
set port vlan-binding-mode 97
set port static-vlan 97
set port channel 98
set port classification 98
set port redundancy on/off 99
set port redundancy 99
set internal buffering 100
set boot bank 100
set intermodule port redundancy 101
set intermodule port redundancy off 102
set port mirror 102
set port spantree 102
set port spantree priority 103
set port spantree cost 103
set port security 104
set cascading 104
set inband vlan 104
set vlan 105
set port flowcontrol 105
set port auto-negotiation-flowcontrol-adver-
tisement 106
set trunk 106
set spantree 106
set spantree priority 107
set autopartition 107
set license 109
set ppp authentication incoming 109
set ppp incoming timeout 110
set ppp baud-rate 110
set web aux-files-url 110
set intelligent-multicast 111
set intelligent-multicast port pruning time 111
set intelligent-multicast router port pruning
time 111
set intelligent-multicast group filtering delay
time 112
set security mode 112
set arp-aging-interval 112
set arp-tx-interval 113
sync time 113
get time 114
reset 114
nvram initialize 115
configure 115
rmon history 115
rmon alarm 116
rmon event 117
copy stack-config tftp 117
copy module-config tftp 118
copy tftp stack-config 119
copy tftp module-config 120
copy tftp EW_archive 120
copy tftp SW_image 121
set radius authentication secret 122
set radius authentication server 123
clear radius authentication server 123
set radius authentication retry-time 123
set radius authentication retry-number 124
set radius authentication udp-port 124
username 125
no username 125