Filter
Top Products
Chapter 5 CLI – Layer 2
106 P332G-ML User’s Guide
Set port auto-negotiation-flowcontrol-advertisement Command
The set port auto-negotiation-flowcontrol-advertisement command
sets the flowcontrol advertisement for a Gigabit port when performing
autonegotiation.
The syntax for this command is:
set port auto-negotiation-flowcontrol-advertisement <mod_num>/
<port_num> {no-flowcontrol|asym-tx-only|sym-only|sym-and-asym-rx}
Example:
P330-N# set port auto-negotiation-flowcontrol-advertisement
1/5 asym-tx-only
P330-N# Port 1/5 pause capabilities was set
Set trunk Command
Use the set trunk command to configure the tagging mode of a post.
set trunk [module/port] [value]
Example:
P330-1(super)# set trunk 2/20 dot1q
Dot1Q VLAN tagging set on port 2/20.
Set spantree Commands
Use the set spantree command to enable/disable the spanning-tree protocol
for the stack.
no-flowcontrol The port will advertise no pause capabilities
asym-tx-only The port will advertise asymmetric Tx pause capabilities only
sym-only The port will advertise symmetric pause capabilities only
sym-and-asym-rx The port will advertise both symmetric and asymmetric Rx
pause capabilities
module/port module/port number
value off/dot1q