Filter
Top Products
Chapter 5 CLI – Layer 2
P332G-ML User’s Guide 99
Example:
P330-1(super)# set port classification 2/19 valuable
Port 2/19 classification has been changed.
Set port redundancy on/off Command
Use the set port redundancy command to define/remove redundancy
schemes between a Primary and a Secondary link. The link can be any port that does
not belong to a LAG, or a LAG interface. In either case, there should not be any
redundancy scheme already defined on any of the links.
The syntax for this command is:
set port redundancy <mod_num>/<prim_port_num> <mod_num>/
<second_port_num> {on/off} [<redundancy_name>]
Example:
P330-N# set port redundancy 1/7 2/12 on red1
uplink: Port 2/12 is redundant to port 1/7.
Port redundancy is active - entry is effective immediately
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".
Set port redundancy Commands
Use the set port redundancy commands to enable or disable the defined
redundancy schemes. Using this command will not delete existing redundancy
entries. A port redundancy scheme is removed once a module is removed from the
stack.
regular |
valuable
port classification
prim_port_num Primary link of the redundancy scheme
second_port_num Secondary link of the redundancy scheme
redundancy_name Name for the redundancy scheme (optional)