Filter
Top Products
Chapter 5 CLI – Layer 2
100 P332G-ML User’s Guide
Note: You must disable Spanning Tree before you can enable redundancy.
The syntax for this command is:
set port redundancy {enable|disable}
Example:
P330-N# set port redundancy enable
All redundancy schemes are now enabled
Set internal buffering Command
The set internal buffering command allows you to set the size (either
Maximum or Minimum) of the Receive (Rx) buffer allocated to each port of the
specified module. This command is meaningless when any port of the module is
operating with flow control ON.
The syntax for this command is:
set internal buffering <mod_num> {max|med|min}
Example:
P330-N> set internal buffering 1 max
Done.
Note: This command is not supported P332G-ML and P332GT-ML modules and
should be used only for the other P330 modules in the stack .
Set boot bank Command
Use the set boot bank command to configure the software bank from which the
module will boot at the next boot process. This command should be issued
separately for each module in the stack using the session command.
max Sets the internal receive buffer to its maximum size.
med Sets the internal receive buffer capacity dynamically
min Sets the internal receive buffer to its minimum size (this is the
Default).