Filter
Top Products
Chapter 5 CLI – Layer 2
92 P332G-ML User’s Guide
The syntax for this command is:
set interface ppp <ip_addr><net-mask>
Example:
P330-N> set interface ppp 149.49.34.125 255.255.255.0
Interface ppp has its ip address set
Use the set interface ppp command to enter modem mode, enter terminal mode,
disconnect the PPP session or to reset the connected modem.
The syntax for this command is:
set interface ppp {enable|enable-always|disable|off|reset}
Example:
P330-N> set interface ppp reset
PPP has reset the connected modem.
P330-N# set interface ppp enable
Entering the Modem mode within 60 seconds...
Please check that the proprietary modem cable is plugged into
the console port
P330-N# set interface ppp disable
Entering the Terminal mode immediately
ip_addr IP address used by the P330 to connect via its PPP interface
net-mask Subnet mask used by the P330 to connect via its PPP interface
enable Enable PPP and enter modem mode.
enable-always Enable automatic reentry into modem mode after modem cable
disconnection or reconnection.
disable Disable PPP and enter terminal mode
off Disconnect the active PPP session.
reset Reset the connected modem.