Filter
Top Products
Chapter 5 CLI – Layer 2
P332G-ML User’s Guide 107
Note: When you disable STP, blocking ports are disabled in order to prevent loops
in the network. As a result, you should wait 30 seconds before disabling STP if you
reset the switch, enabled STP, or inserted a new station.
The syntax for this command is:
set spantree {enable|disable}
Example:
P330-N# set spantree enable
bridge spanning tree enabled.
Set spantree priority Command
Use the set spantree priority command to set the bridge priority for STP.
The syntax for this command is:
set spantree priority <priority>
Example:
This example shows how to set the priority to 45000:
P330-N# set spantree priority 45000
Priority enabled
Set autopartition Command
Use the set autopartition command to enable or disable auto-partitioning on
specific modules of the stack.
The syntax for this command is:
set autopartition <enable|disable>[module]
Example:
P330-N# set autopartition enable 3
Auto-partition is enabled in module 3.
priority Number representing the priority level from 0 to 65535, with 0
indicating high priority and 65535 indicating low priority.