Filter
Top Products
571
APPENDIX B DEVELOPMENT TOOLS
B.2 PROM Programming Tool
B.2.1 Hardware
PG-1500 This is a PROM programmer capable of programming the single-chip microcontroller with on-chip
PROM programmer PROM by manipulating from the stand-alone or host machine through connection of the
separately available programmer adapter and the attached board. It can also program separate
PROM ICs with a capacity from 256 Kbits to 4 Mbits.
PA-78P054GC This is a PROM programmer adapter for the
µ
PD78P058F, 78P058FY, and is used connected to
PROM programmer the PG-1500.
adapter PA-78P054GC: 80-pin plastic QFP (GC-3B9, GC-8BT type)
B.2.2 Software
PG-1500 controller This program controls the PG-1500 from the host machine through serial and/or parallel interface
cable(s).
The PG-1500 controller is a DOS-based application. When using Windows, start it from the DOS
prompt.
Part Number:
µ
S××××PG1500
Remark ×××× of the part number differs depending on the host machine and OS used. Refer to the table below.
µ
S××××PG1500
×××× Host Machine OS Supply Media
5A13 PC-9800 Series MS-DOS 3.5-inch 2HD FD
(Ver. 3.30 to 6.2
Note
)
7B13 IBM PC/AT and Refer to B.4 3.5-inch 2HC FD
compatibles
Note The task swap function cannot be used with this software although this function is
provided in MS-DOS version 5.0 or later.