Filter
Top Products
21264/EV68A Hardware Reference Manual
Privileged Architecture Library Code 6–21
Performance Counter Support
The CMOV instruction is decomposed into two valid fetched instructions that, in the
absence of stalls, are fetched in consecutive cycles. See Table 6–12 for more informa-
tion.
6.10.3.2 Operation
1. Setup
The following IPRs need to be set up by using PALcode instructions.
2. Open window
PCTR0 accumulates up to 4 valid fetched instructions per cycle when enabled via
I_CTL[PCT0_EN] and either I_CTL[SPCE] or PCTX[PPCE].
The valid fetched instruction that causes PCTR0 to overflow opens the window and
becomes the
profiled instruction and covers a period of time near to when the
instruction was in flight. The first cycle of the window is the 5th cycle after the
instruction was fetched. A residual count of up to 7 valid fetched instructions is
accumulated in PCTR0 in the two cycles between overflow and the start of the Pro-
fileMe window. This residual count is returned in I_STAT[overcount(2,0)].
3. Count
If PCTR0 and PCTR1 are enabled, they increment according to modes selected by
SL0 & SL1.
4. End window
The last cycle of the window depends on whether the instruction traps, retires,
aborts, and/or is squashed by the fetcher.
Table 6–12 CMOV Decomposed
Instruction New Instructions
CMOV Ra, Rb--> Rc CMOV1 Ra, oldRc −−> newRc1
CMOV2 newRc1, Rb −−> newRc2
IPR Name Relevant Fields Meaning
IER_CM PCEN[1:0] Enable Interrupts.
PCTX PPCE Enable Process Performance Counting or use I_CTL[SPCE].
PCTR_CTL SL0 Selects Aggregate or ProfileMe mode; set to 1 for ProfileMe mode.
SL1 Selects PCTR0 and PCTR1 counting modes. See Table 6–14 for more infor-
mation.
PCTR0[19:0] Set counter 0 value (2**20-N). This selects approximately the Nth valid
fetched instruction as the profiled instruction. Because writes to PCTR0 are
incremented by 0..4, the profiled instruction is one of the (N-4)th to Nth valid
fetched instructions. See Section 6.10.1 for more setup precautions.
PCTR1[19:0] Set counter 1 value = 0. See Section 6.10.1 for more setup precautions.
I_CTL SPCE Enable System Performance Counting or use PCTX[PPCE].
PCT0_EN Enable performance counter 0.
PCT1_EN Enable performance counter 1.