Filter
Top Products
21264/EV68A Hardware Reference Manual
PALcode Restrictions and Guidelines D–13
Restriction 22: HW_RET/STALL After HW_MTPR IS0/IS1
BIS R31, R31, R31
HW_MTPR R9, ASN0, SCBD<4>
HW_MTPR R9, ASN1, SCBD<7>
This sequence guarantees, through the register dependency on R0, that neither
HW_MTPR are issued before scoreboard bits [7:4] are cleared. In addition, there must
be a HW_RET/STALL after a HW_MTPR ASN0/HW_MTPR ASN1 pair. Finally,
these two writes must be executed atomically, that is, either both must be retired or nei-
ther may be retired.
D.18 Restriction 22: HW_RET/STALL After HW_MTPR IS0/IS1
There must be a scoreboard bit-to-register dependency chain to prevent either
HW_MTPR IS0 or HW_MTPR IS1 from issuing instructions while any of scoreboard
bits [7:4] are set. The following example contains a code sequence that creates the
dependency chain.
HW_MFPR R0, VA, SCBD<7,6,5,4>,R0
XOR R0, R0, R0
BIS R0, R9, R9
BIS R31 ,R31, R31
HW_MTPR R9, IS0, SCBD<6>
HW_MTPR R9, IS1, SCBD<7>
This sequence guarantees, through the register dependency on R0, that neither
HW_MTPR are issued before scoreboard bits [7:4] are cleared. There must be a
HW_RET/STALL after an HW_MTPR IS0/HW_MTPR IS1 pair. Also, these two
writes must be executed atomically, that is, either both must be retired or neither may be
retired.
D.19 Restriction 23: HW_ST/P/CONDITIONAL Does Not Clear the
Lock Flag
A HW_ST/P/CONDITIONAL will not clear the lock flag such that a successive store-
conditional (either STx_C or HW_ST/C) might succeed even in the absence of a load-
locked instruction. In the 21264/EV68A, a store-conditional is forced to fail if there is
an intervening memory operation between the store-conditional and its address-match-
ing LDxL. The following example shows the memory operations.
LDL/Q/F/G/S/T
STL/Q/F/G/S/T
LDQ_U (not to R31)
STQ_U
Absent from this list are HW_LD (any type), HW_ST (any type), ECB, and WH64.
Their absence implies that they will not force a subsequent store-conditional instruction
to fail. PALcode must insert a memory operation from the above list after a HW_ST/
CONDITIONAL in order to force a future store-conditional to fail if it was not pre-
ceded by a load-locked operation:
HW_LDxL