Fujitsu FI-6670A Scanner User Manual


 
Chapter 5 Various Documents
108
Index
Appendix
Introduction
Glossary
Contents
TOP
Loading
Documents
How to Use
ScandAll PRO
Scan Pa-
rameters
Various
Documents
Daily Care
Trouble-
shooting
Operational
Settings
Consumables
Scanner
Overview
Scanner Settings
When using the [Scan/Stop] button
No setting is needed.
Pressing the [Scan/Stop] button starts up the application config-
ured.
When using the [Send to] button
Press the [Function] button to change a number displayed on the
Function Number Display.
When the displayed number and the event number you have
selected in Step 5 ("Send to 1" to "Sent to 9") matches, stop press-
ing the [Function] button.
To perform the event configured with "Send to 2," for example,
display [2] on the Function Number Display.
Pressing the [Send to] button starts up the application you
selected.
Detecting Multifeeds
A "multifeed" is a feeding error that occurs when two or more
sheets in the ADF Paper Chute are fed simultaneously into the
scanner.
You can set the scanner so it will detect multifeeds and display
an error message.
To make the scanner to detect multifeeds, change the settings
in the scanner driver or in the Software Operation Panel.
For how to configure settings in the Software Operation Panel,
refer to "Multifeed Detection" (on page 180).
1 Load a target document on the ADF Paper Chute.
For how to load documents on the ADF Paper Chute, refer to "2.1
Loading Documents on the ADF" (on page 39).
2 Start up ScandAll PRO, and then open the [TWAIN Driver
(32)] dialog box.
For how to open the [TWAIN Driver (32)] dialog box, "Chapter 3 How
to Use ScandAll PRO" (on page 51).
3 Click the [Option] button.
The [Option] dialog box appears.
For details of the Operator Panel, refer to "1.3
Functions of the Operator Panels" (on page 28).
Each time the [Function] button is pressed, the
number displayed changes as follows: 1, 2, 3, …9, C,
1, 2, 3, ….
Check
Function
Send to
Scan / Stop
Power
ADF Type
[Send to] button
[Scan/Stop] button
Check
Function
Send to
Power
Scan / Stop
Flatbed Type
[Send to] button
[Scan/Stop] button