Filter
Top Products
Chapter 7 Consumables
128
Index
Appendix
Introduction
Glossary
Contents
TOP
Loading
Documents
How to Use
ScandAll PRO
Scan Pa-
rameters
Various
Documents
Daily Care
Trouble-
shooting
Operational
Settings
Consumables
Scanner
Overview
6 Attach the Brake Roller to the scanner.
1 Put the Brake Roller by adjusting the flat section of the rotating
shaft to the guide slot of the Brake Roller Holder.
2 Close the Brake Roller Holder.
7 Close the ADF.
Press down on the center of the ADF to return it to its original position
until the ADF clicks into place.
8 Reset the brake roller counter.
Start up the Software Operation Panel, and then reset the counter.
For details, refer to "Resetting the counters" (on page 166).
Be careful, the ADF may close and pinch your
fingers.
• Do not close the ADF while the Brake Roller Cover is
kept open.
• Confirm that the Brake Roller is attached firmly. If not,
paper feed errors such as multifieeds will occur.