Filter
Top Products
Chapter 9 Operational Settings
182
Index
Appendix
Introduction
Glossary
Contents
TOP
Loading
Documents
How to Use
ScandAll PRO
Scan Pa-
rameters
Various
Documents
Daily Care
Trouble-
shooting
Operational
Settings
Consumables
Scanner
Overview
Specifying the Multifeed Detection Range
[Document Check Area Specification for
Multifeed Detection]
The following settings are available only when [Check
Overlapping(Ultrasonic)] is selected.
1 From the tree listing on the left, select [Device Setting 2]
D [Document check area specification for Multifeed
Detection]. Then, select the [Selected range] checkbox.
2 Specify the detection range.
Detection Range Description
Selected range Must be checked to specify the detection
range.
Mark this checkbox to enable the settings
configured in this dialog box. Otherwise, let
the checkbox unmarked.Clearing this check-
box sets both the starting and ending
positions to "0," making the whole range of
the document to be checked for multifeeds.
None Disables the Multifeed Detection for the speci-
fied range.
Enable Enables the Multifeed Detection for the speci-
fied range.
Start Specify the starting position of the detection
range from the leading edge of the document.
The configurable area is from 0 to 510 mm in
2 mm increments, where the starting position
is less than the ending position.
End Specify the ending position of the detection
range from the leading edge of the document.
The configurable area is from 0 to 510 mm in
2 mm increments, where the starting position
is less than the ending position.
Feeding direction
35
Detection
range
Document