Filter
Top Products
Chapter 7 Consumables
126
Index
Appendix
Introduction
Glossary
Contents
TOP
Loading
Documents
How to Use
ScandAll PRO
Scan Pa-
rameters
Various
Documents
Daily Care
Trouble-
shooting
Operational
Settings
Consumables
Scanner
Overview
2 Pull out the two Pick Rollers from the rotating shaft.
5 Attach new two Pick Rollers to the scanner.
1 Attach both of the two Pick Rollers to the rotating shaft.
Insert each roller so its socket will fit to the rotating shaft screw on
the scanner.
2 Close the Pick Roller Cover. Confirm that both sides of the cover
are locked firmly.
6 Attach the ADF Paper Chute.
7 Close the ADF.
Press down on the center of the ADF to return it to its original position
until the ADF clicks into place.
8 Reset the pick roller counter.
Start up the Software Operation Panel, and then reset the counter.
For details, refer to "Resetting the counters" (on page 166).
Be careful, the ADF may close and pinch your
fingers.
• Do not close the ADF while the Pick Roller Cover is
kept open.
• Confirm that the Pick Rollers are attached firmly. If
not, paper feed errors such as paper jams will occur.