Fujitsu FI-6670A Scanner User Manual


 
Chapter 9 Operational Settings
185
Index
Appendix
Introduction
Glossary
Contents
TOP
Loading
Documents
How to Use
ScandAll PRO
Scan Pa-
rameters
Various
Documents
Daily Care
Trouble-
shooting
Operational
Settings
Consumables
Scanner
Overview
Setting A Non-Multifeed-Detection Range
[Intelligent Multifeed Function]
You can bypass multifeed detection by letting the scanner
remembering the pattern (size and location) of glued paper on
the document.
Note that you need to select "Check Overlapping" beforehand
by referring to "Multifeed Detection" (on page 180).
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (on page
156).
2 From the tree listing on the left, select [Device Setting 2]
D [Intelligent Multifeed Function].
3 Select a desired operation mode, and then click the [OK]
button.
To how to work further with the Intelligent Multifeed function, refer to
"Bypassing Multifeed Detection for a Fixed Format" (on page 110).
Operation Mode Description
Manual Mode The scanner stops scanning each time a multi-
feed error is detected. You can resume
scanning after reloading the multifed
document.
The scanner does not remember the size and
location of paper glued on the document.
Auto Mode 1 The scanner remembers the size and location
of paper glued on the document when a multi-
feed error occurs and you reload the multifed
document on the ADF Paper Chute.
Multifeed Detection for this pattern is disabled
from the next scanning on.
Auto Mode 2 The scanner remembers the size of paper
glued on the document when a multifeed error
occurs and you reload the multifed document
on the ADF Paper Chute.
Multifeed Detection for this pattern is disabled
from the next scanning on.
Selecting the [Clear overlap pattern] checkbox clears the
overlapping pattern (size and/or location) memorized in
Auto Mode.
If you change the current mode to another, the remem-
bered pattern (size and/or location) will automatically be
cleared.