Filter
Top Products
Chapter 9 Operational Settings
173
Index
Appendix
Introduction
Glossary
Contents
TOP
Loading
Documents
How to Use
ScandAll PRO
Scan Pa-
rameters
Various
Documents
Daily Care
Trouble-
shooting
Operational
Settings
Consumables
Scanner
Overview
Shorting the Scanning Intervals
[Pre-Pick]
In the case of consecutive scanning, you can direct the
scanner to previously pick the document to be scanned next.
This operation is called Pre-Pick.
By enabling "Pre-Pick," the time interval between the scanning
of two separate documents can be shortened.
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (on page
156).
2 From the tree listing on the left, select [Device Setting 2]
D [Pre-Pick].
3 Configure settings for pre-picking.
Select [Yes] to enable Pre-pick, and select [No] to disable it.
• While Pre-Pick is enabled, if you cancel the scanning
in process, you will have to eject all the pre-picked
document sheets and reload them.
• This setting can also be specified from the scanner
driver’s setting dialog box. Note the setting with the
scanner driver is given a priority.